Engine Specs - S54 Connecting Rods

From Wiki-DIY
Revision as of 20:20, 30 January 2016 by Rcollins (talk | contribs) (Created page with "__FORCETOC__ == Rod Bolt Comparisons == === OEM Rod Bolts === ==== SPEC: OEM: Torque procedure ==== {| class = "diyTable bearingSpec" !Torque !Angle |- |20 Nm |130 degrees...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


Rod Bolt Comparisons

OEM Rod Bolts

SPEC: OEM: Torque procedure

Torque Angle
20 Nm 130 degrees
Remove  
20 Nm 130 degrees
Remove  
20 Nm 130 degrees


Make sure you are starting with new rod bolts.  Factory rod bolts must be replaced once used.

  1. Lubricate rod bolt threads and connecting rod cap bore holes with appropriate thread lubricant.
  2. Torque to 20-Nm, then using a torque-angle gauge tighten another 130-degrees.
  3. Remove bolts.
  4. Repeat steps 1-3
  5. Repeat steps 1, 2.

SPEC: OEM: Clamping Force

  • Clamping Force: Approximately 11000 pounds force.

Retrieved from "http://www.wiki-diy.com/index.php?title=Engine_Specs_-_S54_Connecting_Rods&oldid=1261"